AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST |
| MEASURE LINE PRESSURE |
![]() |
Warm up the ATF.
Remove the test plug from the front side of the transmission case and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check the idling speed.
Keep your left foot firmly on the brake pedal and move the shift lever to D.
Measure the line pressure when the engine is idling.
Depress the accelerator pedal as much as possible with your right foot. Quickly read the highest line pressure reading when the engine speed reaches stall speed.
Perform the measure line pressure test again with the shift lever on R.
| Condition | Shift Lever on D | Shift Lever on R |
| Idling | 360 to 430 kPa (3.7 to 4.4 kgf/cm2, 52 to 62 psi) | 600 to 710 kPa (6.1 to 7.2 kgf/cm2, 87 to 103 psi) |
| Stall | 930 to 1180 kPa (9.5 to 12.0 kgf/cm2, 135 to 171 psi) | 1560 to 1920 kPa (15.9 to 19.6 kgf/cm2, 226 to 278 psi) |
| Problem | Possible Cause |
| Measured values at all positions are higher than specified |
|
| Measured values at all positions are lower than specified |
|
| Pressure is low when shift lever is on D only |
|
| Pressure is low when shift lever is on R only |
|