AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV) > HYDRAULIC TEST |
| MEASURE LINE PRESSURE |
![]() |
Warm up the ATF.
Remove the test plug on the transmission case center right side and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check idling speed.
Keep your left foot firmly on the brake pedal and move the shift lever to D.
Measure the line pressure when the engine is idling.
Depress the accelerator pedal as much a possible. Quickly read the highest line pressure reading when the engine speed reaches stall speed.
Perform the measure line pressure test again with the shift lever on R.
| Condition | Shift Lever on D | Shift Lever on R |
| Idling | 350 to 430 kPa (3.6 to 4.4 kgf/cm2, 51 to 62 psi) | 500 to 600 kPa (5.1 to 6.1 kgf/cm2, 73 to 87 psi) |
| Stall | 1360 to 1480 kPa (13.9 to 15.1 kgf/cm2, 197 to 215 psi) | 1290 to 1520 kPa (13.2 to 15.5 kgf/cm2, 187 to 220 psi) |
| Problem | Possible Cause |
| Measured values at all positions are higher than specified |
|
| Measured values at all positions are lower than specified |
|
| Pressure is low when shift lever is on D only |
|
| Pressure is low when shift lever is on R only |
|