DTC P0724/95 Brake Switch "B" Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0724/95 | Stop light switch remains on even when the vehicle is driven in a stop (less than 3 km/h (2 mph)) and go (30 km/h (19 mph) or more) pattern 5 times (2 trip detection logic). |
|

| 1.READ VALUE USING DATA LIST (STP SIGNAL) |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and push the tester main switch on.
Enter the following menus: Powertrain / ECT / Data List.
Follow the instructions on the tester and read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light Switch | Stop light switch status/ ON or OFF |
| - |
|
| ||||
| NG | |
| 2.INSPECT STOP LIGHT SWITCH |
![]() |
Remove the S14 stop light switch.
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pin not pushed (pedal depressed) | Below 1 Ω |
| 3 - 4 | Pin pushed (pedal released) | Below 1 Ω |
| 1 - 2 | Pin pushed (pedal released) | 10 kΩ or higher |
| 3 - 4 | Pin not pushed (pedal depressed) | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TCM - BATTERY) |
![]() |
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| T17-14 (STP) - Body ground | Brake pedal is depressed | 10 to 14 V |
| T17-14 (STP) - Body ground | Brake pedal is released | Below 1 V |
|
| ||||
| OK | ||
| ||