DTC C1251/51 Open in Pump Motor Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1251/51 | When either condition below is met:
|
|
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Active Test mode on the intelligent tester (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | ABS motor relay | Relay ON / OFF | Operating sound of motor relay can be heard |
Check the operating sound of the ABS motor relay when operating it with the intelligent tester.
| Result | Proceed to |
| The operating sound is not heard | A |
| The operating sound is heard | B |
|
| ||||
| A | |
| 2.INSPECT SKID CONTROL ECU (GND2 TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-13 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Clear the DTC(s) (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC not output | A |
| DTC output | B |
|
| ||||
| A | ||
| ||