Home › ENGINE ยท 2TR-FE › COOLING › RADIATOR

RADIATOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK RADIATOR CAP SUB-ASSEMBLY


    A110260
  1. Measure the valve opening pressure.

    1. If there are water stains or foreign matter on rubber packing 1, 2 or 3, clean the part(s) with water and finger scouring.

    2. Check that 1, 2 or 3 is not deformed, cracked or swollen.

    3. Check that 3 and 4 are not stuck together.

    4. Apply engine coolant to 2 and 3 before using a radiator cap tester.

    5. When using the cap tester, tilt it more than 30°.



    6. A085446E01
    7. Pump the cap tester several times, and check the maximum pressure*.
      Pumping speed: 1 pump per second
      *: Even if the cap cannot maintain the maximum pressure, it is not a defect.

      Judgment criterion:
      Item
      Specified Condition
      Standard value
      (for brand-new cap)
      93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
      Minimum standard value
      (after using cap)
      78.5 kPa (0.8 kgf/cm2, 11.4 psi)

      If the maximum pressure is less than the minimum standard value, replace the radiator cap sub-assembly.