FUEL TANK (for Regular Cab Short Deck) > INSTALLATION |
| 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
Apply a light coat of gasoline or grease to a new gasket, and install it to the fuel tank.
Set the gauge tube to the fuel tank.
Put the retainer on the fuel tank. While holding the pump and gauge tube, tighten the retainer one complete turn by hand.
![]() |
Using SST, tighten the retainer until the mark on the retainer aligns with mark A on the fuel tank, as shown in the illustration.
![]() |
Install the 2 fuel tank tubes with the 2 tube joint clips.
| 2. INSTALL NO. 1 FUEL TANK CUSHION |
![]() |
Install 3 new fuel tank cushions.
![]() |
Install the heat insulator with 5 new clips.
| 3. INSTALL FUEL TANK ASSEMBLY |
Set the fuel tank on a mission jack.
Lift up the mission jack.
Connect the 4 harness clips and fuel pump connector to the fuel tank.
![]() |
Fold back the 2 cushion rubbers.
Install the 3 fuel tank bands with the 3 pins and 3 clips.
![]() |
Connect the 3 fuel tank bands with the 3 bolts.
| 4. INSTALL FUEL TANK FILLER PIPE |
Install the filler pipe with the bolt.
| 5. CONNECT FUEL TANK TO FILLER PIPE HOSE |
Connect the filler pipe hose to the fuel tank filler pipe.
| 6. CONNECT FUEL TANK BREATHER HOSE |
Connect the fuel tank breather hose to the fuel tank filler pipe.
| 7. CONNECT FUEL MAIN TUBE AND FUEL RETURN TUBE |
![]() |
![]() |
Connect the return tube connector to the pipe. Then connect the main tube connector to the pipe. Push the 2 parts together firmly until a "click" sound is heard.
Connect the vent line hose.
| 8. INSTALL NO. 3 FUEL TUBE CLAMP |
![]() |
Install the tube clamp to the fuel tube.
| 9. INSTALL FUEL TANK CAP |
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 12. CHECK FOR FUEL LEAKS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Push the intelligent tester main switch ON.
Select the Active Test and enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check for fuel leaks.
Check that there are no fuel leaks after performing maintenance anywhere on the fuel system.