Home › ENGINE ยท 2KD-FTV › FUEL › FUEL TANK (for Regular Cab Short Deck)

FUEL TANK (for Regular Cab Short Deck) > INSTALLATION

for Preparation Click here



1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Put the retainer on the fuel tank. While holding the pump tube, tighten the retainer one complete turn by hand.



    A111069E04
  1. Using SST, tighten the retainer until the mark on the retainer aligns with mark A on the fuel tank, as shown in the illustration.

    SST
    09808-14020   (09808-01410, 09808-01420, 09808-01430)

    HINT:
    1. If the alignment is difficult, make sure the mark on the retainer is within range B on the fuel tank.
    2. Fit the tips of SST onto the ribs of the retainer.



    A118171E01
  1. Install the 2 fuel pump tubes with the 2 tube joint clips.

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting parts.
    2. Check that the fuel tube joints are inserted securely.
    3. Check that the tube joint clips are on the collars of the fuel tube joints.
    4. After installing the tube joint clips, check that the fuel tube joints have not been pulled off.



2. INSTALL NO. 1 FUEL TANK CUSHION


    A118160
  1. Install 3 new fuel tank cushions.



    A116052
  1. Install the heat insulator with 5 new clips.



3. INSTALL FUEL TANK ASSEMBLY
  1. Set the fuel tank on a mission jack.

  1. Lift up the mission jack.



    A118157E01
  1. Fold back the 2 cushions.

  1. Connect the 4 harness clips and fuel pump connector to the fuel tank.

    NOTICE:
    Be careful not to cut the wirings.



    A118151
  1. Install the 3 fuel tank bands with the 3 pins and 3 clips.

  1. Connect the 3 fuel tank bands with the 3 bolts.

    Torque:
    61 N*m{ 622 kgf*cm , 45 ft.*lbf }



4. INSTALL FUEL TANK FILLER PIPE
  1. Install the filler pipe with the bolt.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }



5. CONNECT FUEL TANK TO FILLER PIPE HOSE
  1. Connect the filler pipe hose to the fuel tank filler pipe.



6. CONNECT FUEL TANK BREATHER HOSE
  1. Connect the fuel tank breather hose to the fuel tank filler pipe.



7. CONNECT FUEL TANK MAIN TUBE AND FUEL TANK RETURN TUBE
  1. Connect the 2 hoses to the 2 tubes.

    NOTICE:
    Check for foreign matter in the pipe and around the connector. Clean if necessary.

  1. Move the clamps to the connection points.



8. TIGHTEN FUEL TANK CAP


9. BLEED AIR FROM FUEL SYSTEM


A098962E01
  1. Using the hand pump, bleed air from the fuel system until pumping becomes difficult.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


11. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



12. CHECK FOR FUEL LEAKS
  1. Start the engine. Check that leaking sounds, sucking sounds or other unusual sounds cannot be heard.