Home › BODY › SEAT › FRONT SEAT ASSEMBLY (w/ Front Seat Side Airbag)

FRONT SEAT ASSEMBLY (w/ Front Seat Side Airbag) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE INNER SEAT TRACK BRACKET COVER


    B206604
  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE OUTER SEAT TRACK BRACKET COVER


    B206605
  1. Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT HEADREST ASSEMBLY


5. REMOVE FRONT SEAT ASSEMBLY


    B211078
  1. Remove the 2 bolts.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B211079
  1. Remove the 2 bolts.

  1. Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.

  1. Disconnect the connectors under the seat.

  1. Remove the seat from the vehicle.

    NOTICE:
    Be careful not to damage the vehicle body.