FRONT SEAT ASSEMBLY (for Separate Seat Type) > REASSEMBLY |
| 1. INSTALL FRONT SEAT CUSHION EDGE PROTECTOR LH (OUTER SIDE) |
| 2. INSTALL RECLINING ADJUSTER ARM SUB-ASSEMBLY LOWER LH |
![]() |
w/ Vertical adjuster:
Using a T40 "torx" socket, install the adjuster arm with the 2 "torx" bolts.
![]() |
w/o Vertical adjuster:
Install the adjuster arm with the 3 bolts.
| 3. INSTALL RECLINING ADJUSTER ARM SUB-ASSEMBLY LOWER RH |
| 4. INSTALL FRONT SEAT ADJUSTER ROD (w/ Vertical Adjuster) |
Install the adjuster rod with the 2 bolts.
| 5. INSTALL SEAT TRACK ADJUSTING HANDLE |
![]() |
Attach the springs to install the handle in the order indicated in the illustration.
| 6. INSTALL VERTICAL ADJUSTING SHAFT SUB-ASSEMBLY (w/ Vertical Adjuster) |
![]() |
Install the adjusting shaft to the reclining adjuster arm with the 2 E-rings.
![]() |
Temporarily install the vertical seat adjuster knob.
Turn the knob as much as possible in the direction indicated by arrow A in the illustration.
Install the gear of the adjusting shaft. Then, align the holes of the adjusting shaft and adjusting arm by turning the knob in the direction indicated by arrow B in the illustration.
Remove the vertical seat adjuster knob.
![]() |
Install the seat spring as shown in the illustration.
Using pliers, push together the tabs that hold the spring.
Install the front seat adjuster pin.
| 7. INSTALL FRONT SEAT CUSHION FRAME SUB-ASSEMBLY LH |
![]() |
Install the cushion frame with the 4 bolts.
| 8. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System) |
![]() |
Set the front seat cushion heater to the seat cushion cover.
Using a tacker, install the front seat cushion heater to the seat cushion cover with the 12 tack pins as shown in the illustration.
| 9. INSTALL FRONT SEAT CUSHION COVER |
![]() |
Using hog ring pliers, install the seat cushion cover to the seat cushion pad with 6 new hog rings.
Install the 2 cushion edge protectors (front side) to the seat cushion frame.
![]() |
Install the seat cushion cover (with pad) to the seat cushion frame.
Using hog ring pliers, attach 7 new hog rings.
Attach the hooks to the hook area in the illustration.
Attach the 2 hooks.
w/ Occupant detection sensor, w/ seat heater system:
Attach the sensor clamp and front seat cushion heater clamp.
| 10. INSTALL SEATBACK SPRING |
| 11. INSTALL FRONT SEATBACK HEATER ASSEMBLY (w/ Seat Heater System) |
Set the seat heater to the seatback cover.
Using a tacker, install the front seat heater to the seatback cover with the 6 tack pins as shown in the illustration.

| 12. INSTALL FRONT SEATBACK COVER |
![]() |
Using hog ring pliers, install the seatback cover to the seatback pad with 4 new hog rings.
Install the seatback cover (with pad) to the seatback spring.
![]() |
Attach the 4 claws to install the 2 headrest supports.
![]() |
Using hog ring pliers, install 7 new hog rings.
| 13. INSTALL FRONT SEATBACK ASSEMBLY |
![]() |
Install the seatback with the 4 bolts.
w/ Seat heater system:
Connect the seatback heater connector.
| 14. INSTALL SEAT TRACK CONTROL CABLE BRACKET LH (w/ Seat Position Memory System) |
![]() |
Install the bracket with the E-ring.
| 15. INSTALL SEAT TRACK CONTROL CABLE BRACKET RH (w/ Seat Position Memory System) |
Install the bracket with the E-ring.
| 16. INSTALL NO. 1 FOLD SEAT LOCK CONTROL CABLE ASSEMBLY LH (w/ Seat Position Memory System) |
| 17. INSTALL NO. 1 FOLD SEAT LOCK CONTROL CABLE ASSEMBLY RH (w/ Seat Position Memory System) |
| 18. INSTALL FRONT SEAT CUSHION SHIELD INNER LH |
![]() |
Install the cushion shield in the order indicated in the illustration.
Install the cushion shield with the 2 screws.
| 19. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH |
| 20. INSTALL FRONT SEAT CUSHION SHIELD LH |
![]() |
Attach the rear part of the cushion shield in the order indicated in the illustration to attach the claw and install the cushion shield.
Install the cushion shield with the 2 screws.
| 21. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH |
![]() |
Install the release handle.
| 22. INSTALL VERTICAL SEAT ADJUSTER KNOB LH |
![]() |
Install the knob with the snap ring.