DTC P0500/42 Vehicle Speed Sensor Malfunction |

| DTC No. | DTC Detection Condition | Suspected Area |
| P0500/42 | While the vehicle is being driven, no vehicle speed sensor signal to the ECM (2 trip detection logic) |
|

| 1.CHECK SPEEDOMETER (OPERATION) |
Drive the vehicle. Check that the speedometer operation is normal.
|
| ||||
| OK | |
| 2.CHECK ECM (SPD VOLTAGE) |
![]() |
Move the shift lever to P or N (for A/T), or neutral (for M/T).
Jack up one of the rear wheels.
Turn the ignition switch ON.
Turn the rear wheel slowly, and measure the voltage of the ECM connectors.
| Tester Connection | Specified Condition |
| E10-8 (SPD) - E12-3 (E1) | Voltage is generated intermittently |
| Tool Setting | Condition |
| 2 V/DIV., 10 msec./DIV. | Turn the rear wheel slowly |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (COMBINATION METER - ECM) |
![]() |
Disconnect the C8 combination meter connector.
Disconnect the E10 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C8-6 - E10-8 (SPD) | Below 1 Ω |
| C8-6 or E10-8 (SPD) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||