ECD SYSTEM > MIL Circuit |

| 1.CHECK MIL CONDITION |
| Condition | Proceed to |
| MIL remains ON | A |
| MIL does not illuminate | B |
|
| ||||
| A | |
| 2.CHECK IF MIL TURNS OFF |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Check if DTCs have been stored (Click here). If DTCs are present, write them down.
Clear the DTCs using the intelligent tester (Click here).
Check that the MIL turns off.
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (FOR SHORT) |
![]() |
Disconnect the E20 ECM connector.
Turn the ignition switch ON.
Check that the MIL is not illuminated.
|
| ||||
| NG | |
| 4.CHECK WIRE HARNESS (ECM - COMBINATION METER) |
![]() |
Disconnect the E20 ECM connector.
Disconnect the C8 combination meter connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E20-5 (W) - C8-39 | Below 1 Ω |
| E20-5 (W) or C8-39 - Body ground | 10 kΩ or higher |
|
| ||||
| NG | ||
| ||
| 5.CHECK IF MIL ILLUMINATES |
Check that the MIL illuminates when turning the ignition switch ON.
|
| ||||
| NG | |
| 6.INSPECT COMBINATION METER (MIL CIRCUIT) |
See the combination meter troubleshooting procedures (Click here).
|
| ||||
| OK | ||
| ||