FRONT PROPELLER SHAFT ASSEMBLY (for TSAM Made) > REASSEMBLY |
| 1. INSTALL UNIVERSAL JOINT SPIDER ASSEMBLY |
![]() |
Apply MP grease to a new spider and 2 new spider bearings.
Fit the spider into the flange yoke.
![]() |
Using SST, install the 2 spider bearings to the spider.
![]() |
Using SST, adjust the spider bearings so that: 1) the flange yoke does not overlap the snap ring grooves of the spider bearings, and the grooves are as wide as possible; and 2) the groove width on both sides is the same.
Install 2 new snap rings to the installed spider bearings. The snap rings must have equal thickness which will allow 0 to 0.05 mm (0 to 0.0020 in.) of axial play.
| Part No. | Thickness | Color |
| 90080-52174 | 1.38 mm (0.0543 in.) | Green |
| 90080-52044 | 1.384 mm (0.0545 in.) | Green |
| 90080-52043 | 1.435 mm (0.0565 in.) | Red |
| 90080-52175 | 1.45 mm (0.0571 in.) | Orange |
| 90080-52176 | 1.48 mm (0.0583 in.) | Black |
| 90080-52041 | 1.486 mm (0.0585 in.) | Black |
| 90080-52176 | 1.48 mm (0.0583 in.) | Black |
| 90080-52042 | 1.511 mm (0.0595 in.) | Copper |
| 90080-52040 | 1.537 mm (0.0605 in.) | Silver |
| 90080-52178 | 1.54 mm (0.0606 in.) | Yellow |
| 90080-52039 | 1.588 mm (0.0625 in.) | Yellow |
| 90080-52179 | 1.63 mm (0.0642 in.) | Red |
| 90080-52038 | 1.638 mm (0.0645 in.) | Blue |
| 90080-52180 | 1.68 mm (0.0661 in.) | Blue |
![]() |
Using a hammer, tap the flange yoke until there is no clearance between the spider bearings and snap rings.
Align the matchmarks on the flange yoke and sleeve yoke.
Install new spider bearings on the sleeve yoke side.
| 2. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY |
Check the spider bearings for wear or damage.
Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.
| 3. INSTALL SLIDING SHAFT BOOT |
Temporarily install the boot (with 2 new clamps) to the propeller shaft.
Mount the propeller shaft in a soft vise.
Coat the splines of the propeller shaft with MP grease.
Align the matchmarks on the propeller shaft and sleeve yoke.
Install the sleeve yoke to the propeller shaft and connect the boot.
![]() |
Secure one of the boot clamps onto the boot.
Place SST onto the boot clamp.
Tighten SST so that the boot clamp is pinched as shown in the illustration.
![]() |
Using SST, adjust the clearance of the boot clamp.
For the remaining boot clamp, use the same procedures described above.
| 4. INSPECT PROPELLER SHAFT GREASE FITTING DIRECTION |
