FRONT AXLE HUB (for 2WD) > INSTALLATION |
| 1. INSTALL FRONT AXLE HUB INNER BEARING |
![]() |
Using SST and a press, press a new bearing into the steering knuckle.
Using snap ring pliers, install a new snap ring.
| 2. INSTALL FRONT AXLE HUB OIL SEAL |
![]() |
Using SST and a plastic-faced hammer, tap in a new oil seal.
Apply MP grease to the lip of the oil seal.
| 3. INSTALL AXLE HUB TO STEERING KNUCKLE |
![]() |
Install the dust cover to the steering knuckle with the 3 bolts.
Using SST and a press, press the axle hub into the steering knuckle.
| 4. INSTALL FRONT AXLE HUB NUT AND ABS SPEED SENSOR ROTOR OR SPACER |
![]() |
w/ ABS:
Install the ABS speed sensor rotor.
w/o ABS:
Install the spacer.
Install a new nut to the axle hub.
Using a chisel and hammer, stake the nut.
| 5. INSTALL KNUCKLE GREASE RETAINER CAP |
![]() |
Using a brass bar and hammer, install the knuckle grease retainer cap.
| 6. INSTALL FRONT AXLE HUB ASSEMBLY |
| 7. CONNECT FRONT SUSPENSION UPPER ARM ASSEMBLY LH |
![]() |
Connect the upper arm with the nut.
Install a new clip.
| 8. CONNECT FRONT SUSPENSION LOWER ARM ASSEMBLY WITH ATTACHMENT LH |
![]() |
Connect the suspension arm with the 2 bolts.
| 9. INSTALL TIE ROD END SUB-ASSEMBLY |
![]() |
Connect the tie rod end with the nut.
Install a new cotter pin.
| 10. INSTALL FRONT DISC |
| 11. INSTALL FRONT SPEED SENSOR LH |
![]() |
Install the speed sensor with the bolt.
Connect the 3 clamps with the 3 bolts.
| 12. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH |
![]() |
Install the brake cylinder with the 2 bolts.
Connect the brake hose to the brake cylinder with the union bolt and a new gasket.
| 13. BLEED AIR FROM BRAKE LINE |
TMT made LHD:
Bleed air from the brake line (Click here).
TMT made RHD:
Bleed air from the brake line (Click here).
| 14. CHECK BRAKE FLUID LEVEL IN RESERVOIR |
TMT made LHD:
Check the brake fluid level in reservoir (Click here).
TMT made RHD:
Check the brake fluid level in reservoir (Click here).
| 15. CHECK FOR BRAKE FLUID LEAKAGE |
Check for brake fluid leakage (Click here).
| 16. INSTALL FRONT WHEEL |
| 17. CHECK ABS SPEED SENSOR SIGNAL |
Check the ABS speed sensor signal (Click here).