ANTI-LOCK BRAKE SYSTEM (w/ Rear Differential Lock) > TERMINALS OF ECU |
| CHECK BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU WITH ACTUATOR) |

Measure the voltage of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
| +BS (S2-1) - GND (S2-2, 24) | W-R - W-B | Solenoid relay power supply | Always | 10 to 14 V |
| EXI4*1 (S2-3) - GND (S2-2, 24) | G-W - W-B | L4 switch input | Ignition switch ON, L4 switch ON | Below 1.5 V |
| EXI4*1 (S2-3) - GND (S2-2, 24) | G-W - W-B | L4 switch input | Ignition switch ON, L4 switch OFF | 8 to 14 V |
| GL1*1, *4(S2-4) - GND (S2-2, 24) | R - W-B | Deceleration sensor input | Ignition switch ON, vehicle is stopped | 0.5 to 4.5 V |
| GGND*1 (S2-7) - GND (S2-2, 24) | B - W-B | Deceleration sensor GND | Ignition switch OFF | Below 1.5 V |
| FL+ (S2-9) - FL (S2-8) | R - G | Front speed sensor LH input | Ignition switch ON, slowly turn left front wheel | Pulse generation |
| STP (S2-10) - GND (S2-2, 24) | G-W - W-B | Stop light switch input | Stop light switch ON | 8 to 14 V |
| STP (S2-10) - GND (S2-2, 24) | G-W - W-B | Stop light switch input | Stop light switch OFF | Below 1.5 V |
| RL+ (S2-11) - RL (S2-12) | P - L | Rear speed sensor LH input | Ignition switch ON, slowly turn left rear wheel | Pulse generation |
| WA (S2-13) - GND (S2-2, 24) | R-G - W-B | ABS warning light output | Ignition switch ON, ABS warning light ON | 9 to 14 V |
| WA (S2-13) - GND (S2-2, 24) | R-G - W-B | ABS warning light output | Ignition switch ON, ABS warning light OFF | Below 1 V |
| D/G (S2-14) - GND (S2-2, 24) | L-Y - W-B | Diagnosis tester communication line | Ignition switch ON | 10 to 14 V |
| TS (S2-15) - GND (S2-2, 24) | W - W-B | Terminal TS of DLC3 | Ignition switch OFF | Below 1.5 V |
| TS (S2-15) - GND (S2-2, 24) | W - W-B | Terminal TS of DLC3 | Ignition switch ON | 10 to 14 V |
| TC (S2-16) - GND (S2-2, 24) | P-L - W-B | Terminal TC of DLC3 | Ignition switch OFF | Below 1.5 V |
| TC (S2-16) - GND (S2-2, 24) | P-L - W-B | Terminal TC of DLC3 | Ignition switch ON | 10 to 14 V |
| EXI*1 (S2-17) - GND (S2-2, 24) | R-B - W-B | Differential vacuum actuator switch input | Ignition switch ON, differential vacuum actuator switch ON | Below 1.5 V |
| EXI*1 (S2-17) - GND (S2-2, 24) | R-B - W-B | Differential vacuum actuator switch input | Ignition switch ON, differential vacuum actuator switch OFF | 10 to 14 V |
| PKB (S2-18) - GND (S2-2, 24) | L-O*2 - W-B LG*3 - W-B | Parking brake switch input | Ignition switch ON, parking brake switch ON | Below 1.5 V |
| PKB (S2-18) - GND (S2-2, 24) | L-O*2 - W-B LG*3 - W-B | Parking brake switch input | Ignition switch ON, parking brake switch OFF | 10 to 14 V |
| EXI2 (S2-22) - GND (S2-2, 24) | V - W-B | Transfer indicator switch (rear differential lock) input | Ignition switch ON, rear differential lock switch ON | Below 1 V |
| EXI2 (S2-22) - GND (S2-2, 24) | V - W-B | Transfer indicator switch (rear differential lock) input | Ignition switch ON, rear differential lock switch OFF | 10 to 14 V |
| +BM (S2-23) - GND (S2-2, 24) | R - W-B | Motor relay power supply | Always | 10 to 14 V |
| IG1 (S2-25) - GND (S2-2, 24) | B - W-B | IG1 power supply | Ignition switch ON | 10 to 14 V |
| VGS*1, *4(S2-28) - GND (S2-2, 24) | W - W-B | Deceleration sensor power supply | Ignition switch ON, vehicle is stopped | 4.75 to 5.25 V |
| FR+ (S2-31) - FR (S2-30) | L-W - O | Front speed sensor RH input | Ignition switch ON, slowly turn right front wheel | Pulse generation |
| RR+ (S2-33) - RR (S2-34) | G - R | Rear speed sensor RH input | Ignition switch ON, slowly turn right rear wheel | Pulse generation |