DTC C0210/33 Right Rear Wheel Speed Sensor Signal Malfunction |
DTC C0215/34 Left Rear Wheel Speed Sensor Signal Malfunction |
DTC C1238/38 Foreign Object is Attached on Tip of Rear Speed Sensor RH |
DTC C1239/39 Foreign Object is Attached on Tip of Rear Speed Sensor LH |
DTC C1273/73 Low Output Signal of Rear Speed Sensor RH (Test Mode DTC) |
DTC C1274/74 Low Output Signal of Rear Speed Sensor LH (Test Mode DTC) |
DTC C1277/77 Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC) |
DTC C1278/78 Abnormal Change in Output Signal of Rear Speed Sensor LH (Test Mode DTC) |
| DTC No. | DTC Detection Condition | Trouble Area |
| C0210/33 C0215/34 | When one of following occurs
|
|
| C1238/38 C1239/39 | At vehicle speed of 20 km/h (12 mph) or more, condition that noise is included in speed sensor signal continues for 5 sec. or more. |
|
| C1273/73 | Detected only during test mode |
|
| C1274/74 | Detected only during test mode |
|
| C1277/77 | Detected only during test mode |
|
| C1278/78 | Detected only during test mode |
|

| 1.CHOOSE DIAGNOSIS METHOD |
Choose the diagnosis method.
| Method | Proceed to |
| Using intelligent tester | A |
| Not using intelligent tester | B |
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (REAR SPEED SENSOR) |
Check the Data List for proper functioning of the rear speed sensor.
| Item | Measurement Item / Range (Display) | Normal Condition | Diagnostic Note |
| RR Wheel Speed | Wheel speed sensor (RR) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) | Actual wheel speed | Speed similar to that of speedometer |
| RL Wheel Speed | Wheel speed sensor (RL) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) | Actual wheel speed | Speed similar to that of speedometer |
|
| ||||
| OK | |
| 3.INSPECT SPEED SENSOR AND SENSOR ROTOR SERRATIONS |
![]() |
Connect an oscilloscope to terminals 33 (RR+) and 34 (RR-), and 11 (RL+) and 12 (RL-) of the S2 skid control ECU connector.
Drive the vehicle at about 30 km/h (19 mph), and check the signal waveform.
|
| ||||
| OK | ||
| ||
| 4.INSPECT REAR SPEED SENSOR |
![]() |
Disconnect the S40 and S41 rear speed sensor connectors.
Measure the resistance of the speed sensors.
| Tester Connection | Specified Condition |
| 1 - 2 | 0.65 to 1.8 kΩ |
| 1 - Body ground | 10 kΩ or higher |
| 2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (SKID CONTROL ECU - REAR SPEED SENSOR) |
![]() |
Disconnect the S2 ECU connector.
Disconnect the S40 and S41 rear speed sensor connectors.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| S2-11 (RL+) - S40-2 | Below 1 Ω |
| S2-12 (RL-) - S40-1 | Below 1 Ω |
| S40-2 - Body ground | 10 kΩ or higher |
| S40-1 - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| S2-33 (RR+) - S41-2 | Below 1 Ω |
| S2-34 (RR-) - S41-1 | Below 1 Ω |
| S41-2 - Body ground | 10 kΩ or higher |
| S41-1 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.INSPECT SPEED SENSOR AND SENSOR ROTOR SERRATIONS |
![]() |
Connect an oscilloscope to terminals 33 (RR+) and 34 (RR-), and 11 (RL+) and 12 (RL-) of the S2 skid control ECU connector.
Drive the vehicle at about 30 km/h (19 mph), and check the signal waveform.
|
| ||||
| OK | |
| 7.CHECK IF DTC OUTPUT RECURS |
Clear the DTCs.
Drive the vehicle at approximately 30 km/h (19 mph) or more for 60 seconds or more.
Check for DTCs.
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||
| 8.INSPECT REAR SPEED SENSOR (INSTALLATION) |
![]() |
Check the rear speed sensor installation (Click here).
|
| ||||
| OK | |
| 9.INSPECT REAR SPEED SENSOR (TIP) |
Remove the rear speed sensor.
Check the sensor tip.
|
| ||||
| OK | |
| 10.INSPECT SPEED SENSOR ROTOR |
Remove the rear axle shaft with backing plate.
Check the sensor rotor serrations.
|
| ||||
| OK | |
| 11.CHECK IF DTC OUTPUT RECURS |
Clear the DTCs.
Drive the vehicle at approximately 30 km/h (19 mph) or more for 60 seconds or more.
Check for DTCs.
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||