Home › BRAKE › BRAKE CONTROL › FRONT SPEED SENSOR (for 4WD and Pre-Runner)

FRONT SPEED SENSOR (for 4WD and Pre-Runner) > REMOVAL

for Preparation Click here


HINT:
  1. The procedures listed below are for the LH side.
  2. Other than areas where instructions are provided, use the same procedures for the LH side and RH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT WHEEL


3. REMOVE FRONT SPEED SENSOR LH


  1. Disconnect the connector.


    C188016E01

  1. Detach the 2 clamps and the connector.



    C188017E01
  1. Detach the 2 clamps.



    C189998E01
  1. Detach the clamp.

  1. Remove the 2 bolts and 2 harness clamps.



  1. Detach the 2 clamps.


    C188002E01

  1. Remove the bolt and harness clamp.

  1. Remove the bolt and speed sensor.

    NOTICE:
    Keep the sensor tip and sensor installation hole free from foreign matter.



4. REMOVE SKID CONTROL SENSOR CLAMP


  1. Remove the bolt and skid control sensor clamp from the knuckle.


    C189974E01