Home › BRAKE › BRAKE › FRONT BRAKE (for TSAM Made 2WD)

FRONT BRAKE (for TSAM Made 2WD) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE FRONT FLEXIBLE HOSE


C121982
  1. Remove the union bolt and gasket.

  1. Disconnect the flexible hose from the brake cylinder.



4. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH


C121983
  1. Remove the 2 bolts and cylinder.