FRONT BRAKE (for TSAM Made 2WD) > DISASSEMBLY |
| 1. REMOVE FRONT DISC BRAKE PAD |
Remove the 2 disc brake pads.
| 2. REMOVE ANTI SQUEAL SHIM KIT FRONT |
Remove the shims from each pad.
| 3. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE |
Remove the 2 plates from the brake cylinder mounting.
| 4. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING |
![]() |
Remove the 2 bolts and cylinder mounting.
| 5. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN |
![]() |
Remove the 2 pins (upper and lower) from the mounting.
![]() |
Using a screwdriver, remove the slide bush from the pin (lower).
| 6. REMOVE FRONT DISC BRAKE BUSH DUST BOOT |
![]() |
Remove the 2 boots from the mounting.
| 7. REMOVE CYLINDER BOOT |
![]() |
Using a screwdriver, pry out the set ring and boot.
| 8. REMOVE FRONT DISC BRAKE PISTON |
![]() |
Prepare a wooden plate to hold the pistons.
![]() |
Place the wooden plate between the piston and cylinder.
Use compressed air to remove the piston from the cylinder.
| 9. REMOVE PISTON SEAL |
![]() |
Using a screwdriver, pry out the seal from the cylinder.
| 10. REMOVE FRONT DISC BRAKE BLEEDER PLUG |
Remove the bleeder plug cap and bleeder plug from the cylinder.
| 11. REMOVE FRONT DISC |
![]() |
Put matchmarks on the disc and axle hub.
Remove the disc.