Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION ASSEMBLY

AUTOMATIC TRANSMISSION ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 2 FRAME CROSSMEMBER SUB-ASSEMBLY


G034583E01
  1. Remove the 4 nuts, 4 bolts and frame crossmember.



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the front exhaust pipe (Click here).



4. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. Remove the propeller with center bearing shaft assembly (Click here).



5. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }



6. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


C118024
  1. Remove the oil dipstick.

  1. Remove the 2 bolts and oil filler tube.

  1. Remove the O-ring from the oil filler tube.



7. DISCONNECT OIL COOLER TUBE


C118031
  1. Using a union nut wrench, disconnect the tube outlet and tube inlet.



    C118032
  1. Remove the 3 bolts and 3 clamps.



8. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


G034515E01
  1. Remove the nut and disconnect the control cable.

  1. Remove the clip and disconnect the control cable.



9. REMOVE TRANSMISSION CONTROL CABLE BRACKET


G034516E01
  1. Remove the 2 bolts and control cable bracket from the transmission.



10. REMOVE STARTER ASSEMBLY

HINT:
Refer to "2TR-FE STARTING-STARTER-REMOVAL" and remove the starter.



11. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY


G034520E01
  1. Support the transmission with a transmission jack.



12. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY


G034517E01
  1. *1: Remove the 4 set bolts of the No. 1 engine mounting insulator rear.

  1. *2: Remove the 4 nuts, 4 bolts and frame crossmember.



13. DISCONNECT CONNECTOR


G034521E01
  1. Tilt the transmission downward.

    NOTICE:
    Make sure the cooling fan does not contact the fan shroud.

  1. Disconnect the connectors.

    1. Disconnect the temperature sensor connector.

    2. Disconnect the park/neutral position switch connector.

    3. Disconnect the 3 speed sensor connectors.

    4. Disconnect the transmission wire connector.



14. DISCONNECT WIRE HARNESS


15. REMOVE FLYWHEEL HOUSING DUST SEAL


16. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY


C118033
  1. Turn the crankshaft to gain access to each bolt.

  1. Hold the crankshaft pulley bolt with a wrench and remove the 6 torque converter clutch mounting bolts.



    C118034
  1. Remove the 3 bolts and exhaust manifold stay.



    C118035
  1. Remove the 7 bolts.

  1. Separate the transmission from the engine.



17. REMOVE NO. 1 ENGINE MOUNTING INSULATOR REAR


G034579E01
  1. Remove the 4 bolts and engine mounting insulator.



18. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY