Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner)

FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner) > INSTALLATION

for Preparation Click here



1. TEMPORARILY INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH


C113163E01
  1. Temporarily install the upper arm with the bolt, 2 retainers and nut.

    HINT:
    Fix the nut in place and temporarily install the bolt.

  1. Install the upper arm to the steering knuckle with a nut.

    Torque:
    110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }

  1. Install a new clip.



2. CONNECT SKID CONTROL SENSOR WIRE
  1. Connect the skid control sensor wire (Click here).



3. INSTALL FRONT WHEEL
  1. Install the front wheel.

    Torque:
    105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }



4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



5. TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH
  1. Tighten the upper arm's bolt.

    Torque:
    115 N*m{ 1,173 kgf*cm , 85 ft.*lbf }

    NOTICE:
    Do not tighten the nut.



6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
Refer to "SUSPENSION - FRONT WHEEL ALIGNMENT - ADJUSTMENT" applicable to this vehicle model and perform the inspection and adjustment.