Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM (for 2WD)

FRONT UPPER SUSPENSION ARM (for 2WD) > INSTALLATION

for Preparation Click here



1. TEMPORARILY INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH


F049917E01
  1. Temporarily install the upper arm with the 2 bolts and 2 nuts.

    HINT:
    Fix the nuts in place and temporarily install the bolts.

  1. Install the upper arm to the front axle with a nut.

    Torque:
    110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }

  1. Install a new clip.



2. CONNECT SKID CONTROL SENSOR WIRE
  1. Connect the skid control sensor wire (Click here).



3. INSTALL FRONT WHEEL
  1. Install the front wheel.

    Torque:
    152 N*m{ 1,550 kgf*cm , 112 ft.*lbf } for steel wheel
    121 N*m{ 1,234 kgf*cm , 89 ft.*lbf } for aluminum wheel



4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



5. TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH
  1. Tighten the upper arm's 2 bolts.

    Torque:
    85 N*m{ 867 kgf*cm , 63 ft.*lbf }



6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
Refer to "SUSPENSION - FRONT WHEEL ALIGNMENT - ADJUSTMENT" applicable to this vehicle model and perform the inspection and adjustment.