Home › ENGINE ยท 5L-E › FUEL › FUEL INJECTION NOZZLE

FUEL INJECTION NOZZLE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. DISCONNECT AIR CLEANER HOSE
  1. Disconnect the IAT sensor connector.

  1. Detach the clamp of the IAT sensor harness.

  1. Loosen the 2 clamps from the air cleaner hose.

  1. Remove the air cleaner hose.



3. REMOVE INTAKE PIPE ASSEMBLY


    A114290
  1. Remove the 2 bolts and loosen the hose clamp.



4. REMOVE VENTURI


    A111052E02
  1. Disconnect the throttle open switch connector.



    A111053E02
  1. Disconnect the throttle control motor connector.

  1. Remove the venturi and gasket.



5. REMOVE INJECTION PIPE SET


    A121940E01
  1. Using SST, loosen the 8 union nuts of the 4 injection pipes.

    SST
    09023-12701  

  1. Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes with lower pipe clamps.



6. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Remove the nut and wire harness.

  1. Remove the 4 screw grommets, 4 nuts and glow plug connector.



7. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY


    A121941
  1. Disconnect the fuel hose from the leakage pipe.

  1. Remove the 4 nuts, leakage pipe and 4 ring packing washers.



8. REMOVE NOZZLE HOLDER AND NOZZLE SET


    A121942E01
  1. Using SST, remove the 4 injection nozzles, 4 injection nozzle seats and 4 injection nozzle seat gaskets.

    SST
    09268-64010   (09268-64020)