REPAIR INSTRUCTION > INITIALIZATION |
| System Name |
| ECD System |
| Vehicle Stability Control System |
| Power Window Control System |
| Meter / Gauge System |
| INITIALIZATION RELATED TO ECD SYSTEM |
SUPPLY PUMP INITIALIZATION PROCEDURE
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine / Utility / Supply Pump Initialization.
Press Next.
![]() |
Press Next.
![]() |
Press Exit.
Start the engine to check if the initialization is complete. If the engine cannot be started, repeat the initialization procedures from the beginning.
Idle the engine for at least 1 minute under the following conditions (Procedure "A"):
Initialization is complete (Procedure "B").
| CALIBRATION RELATED TO VEHICLE STABILITY CONTROL SYSTEM |
DESCRIPTION
Follow the chart below to perform calibration.
| Parts to be Replaced / Operation | Necessary Operation |
| Skid control ECU (Brake actuator assembly) | Yaw rate and acceleration sensor zero point calibration |
| Yaw rate and acceleration sensor |
|
| Front wheel alignment adjustment |
|
OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When Using Intelligent Tester)
Clear the zero point calibration data.
Perform the zero point calibration of the yaw rate and acceleration sensor.
![]() |
OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When not Using Intelligent Tester)
Clear the zero point calibration data.
![]() |
Perform the zero point calibration of the yaw rate and acceleration sensor.
![]() |
![]() |
| RESET (INITIALIZE) POWER WINDOW REGULATOR MOTOR (for Driver Side) |
Turn the ignition switch ON.
Open the power window halfway by pressing the power window switch.
Fully pull up on the switch until the power window is fully closed and continue to hold the switch for at least 1 second.
Check that the AUTO UP / DOWN function operates normally.
If the AUTO UP / DOWN function operates normally, reset operations are completed. If abnormal, follow the 3 steps below.
Disconnect the cable from the negative (-) battery terminal for 10 seconds.
Connect the cable to the negative (-) battery terminal.
Perform the first 4 steps again.
If the AUTO UP / DOWN function operates normally, reset operations have been completed at this time. If abnormal, follow the 4 steps below.
Turn the ignition switch ON.
Open the power window halfway by pressing the power window switch.
Fully pull up on the switch until the power window is fully closed and continue to hold the switch for approximately 12 seconds after the power window is fully closed.
Check that the AUTO UP / DOWN function operates normally.
| RESET COMPASS IN COMBINATION METER |
Circling calibration
Select compass mode.
Press and hold INFO for 3 seconds to enter the compass correction mode.
Press RESET.
Drive the vehicle slowly in a circle once within 128 seconds.
If there is not enough space to drive in a circle, perform the following:
Compass correction mode cancellation
Press RESET after performing the circling calibration.
Press INFO or wait for 6 seconds to end the compass correction mode.
Zone setting
Select compass mode.
Press and hold INFO for 3 seconds to enter compass correction mode.
Press H to select a higher zone number.
Press M to select a lower zone number.
Press INFO or wait for 6 seconds to end compass correction mode.

