FRONT AXLE HUB (for 4WD and Pre-Runner) > INSTALLATION |
| 1. INSTALL PLUG (for Pre-Runner) |
![]() |
Using a brass bar and hammer, tap in a plug.
| 2. INSTALL FRONT AXLE HUB OIL SEAL |
![]() |
Using a brass bar and hammer, tap in a new oil seal.
| 3. INSTALL FRONT AXLE BEARING ASSEMBLY (for 4WD) |
![]() |
Using SST and a press, press a new bearing into the axle hub.
w/ ABS:
Install the spacer and ABS rotor to the axle hub.
w/o ABS:
Install the 2 spacers to the axle hub.
| 4. INSTALL FRONT AXLE BEARING ASSEMBLY (for Pre-Runner) |
![]() |
Using SST and a press, press a new bearing into the axle hub.
w/ ABS:
Install the sensor rotor to the axle hub.
w/o ABS:
Install the spacer to the axle hub.
![]() |
Using SST, install a new adjusting nut.
| 5. INSTALL FRONT AXLE HUB ASSEMBLY |
![]() |
Apply MP grease to a new O-ring.
Install the new O-ring to the axle hub.
Install the dust cover and axle hub to the steering knuckle with the 4 bolts.
| 6. INSTALL FRONT AXLE HUB NUT LH (for 4WD) |
![]() |
Install the hub nut.
Install the adjusting cap and a new cotter pin.
| 7. INSTALL FRONT AXLE HUB GREASE CAP (for 4WD) |
Install a new grease cap to the axle hub.
| 8. INSTALL FRONT DISC |
| 9. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the disc brake caliper with the 2 bolts.
![]() |
Install the brake tube bracket to the steering knuckle with the bolt.
![]() |
Using SST, connect the brake tube to the disc brake caliper.
| 10. INSTALL FRONT SPEED SENSOR LH |
![]() |
Install the speed sensor with the bolt.
Connect the 2 clamps.
Install the speed sensor wire harness to the steering knuckle with the bolt.
| 11. INSTALL FRONT WHEEL |
| 12. CHECK ABS SPEED SENSOR SIGNAL |
Check the ABS speed sensor signal (Click here).