Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Fuel Gauge Malfunction

for Preparation Click here


WIRING DIAGRAM


E115291E07


INSPECTION PROCEDURE

1.CHECK FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (FUEL SENDER GAUGE)
E110269E01
  1. Disconnect the F15*1 or F13*2 pump and gauge connector.

  1. Turn the ignition switch ON, and then check the position of the receiver gauge needle.

    OK:
    Fuel receiver gauge indicates E.

    HINT:
    *1: 1TR-FE, 2TR-FE, 1GR-FE
    *2: 1KD-FTV, 2KD-FTV, 5L-E

  1. Connect terminals 2 and 3 on the wire harness side connector.

  1. Turn the ignition switch ON, and then check the position of the receiver gauge needle.

    OK:
    Fuel receiver gauge indicates F.



OK
REPLACE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
NG


2.CHECK WIRE HARNESS (METER - GAUGE)

E117785E02

  1. Disconnect the C8 meter connector.

  1. Disconnect the F15*1 or F13*2 pump and gauge connector.

HINT:
*1: 1TR-FE, 2TR-FE, 1GR-FE
*2: 1KD-FTV, 2KD-FTV, 5L-E

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    1TR-FE, 2TR-FE, 1GR-FE 
    Tester Connection
    Specified Condition
    C8-2 - F15-3
    Below 1 Ω
    C8-3 - F15-2

    1KD-FTV, 2KD-FTV, 5L-E:
    Tester Connection
    Specified Condition
    C8-2 - F13-3
    Below 1 Ω
    C8-3 - F13-2



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY