Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR

REAR SPEED SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR SPEED SENSOR


  1. Measure the resistance of the sensor.


    C225645E01

    Standard Resistance:
    Tester Connection
    Specified Condition
    1 - 2
    0.65 to 1.8 kΩ
    1 - Body ground
    10 kΩ or higher
    2 - Body ground
    10 kΩ or higher

    1. If the result is not as specified, replace the speed sensor.

    HINT:
    Check the speed sensor signal after speed sensor replacement .



2. INSPECT REAR SPEED SENSOR (SKID CONTROL SENSOR WIRE)


  1. Measure the resistance of the rear speed sensor (skid control sensor wire).


    C225543E02

    Standard Resistance:
    Tester Connection
    Specified Condition
    1 - 2
    0.65 to 2.0 kΩ
    1 - Body ground
    10 kΩ or higher
    2 - Body ground
    10 kΩ or higher

    If the result is not as specified, replace the rear speed sensor (skid control sensor wire).

    HINT:
    Check the speed sensor signal after rear speed sensor (skid control sensor wire) replacement (Click here).