Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for 2 Person Bench Seat Type)

FRONT SEAT INNER BELT ASSEMBLY (for 2 Person Bench Seat Type) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for RHD and LHD vehicles.
  2. The procedures listed below are for LHD vehicles.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT SEAT ASSEMBLY


    B122861E01
  1. Pull the inner belts out from the bottom of the seat cushion.

  1. Remove the 4 bolts.

  1. w/ Occupant detection sensor:
    Disconnect the connector under the seat.

  1. Remove the seat.

    NOTICE:
    Be careful not to damage the vehicle body.



3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH


B087811E01
  1. Detach the clamp.



    B089297E01
  1. Detach the wire harness from the clamp.

  1. Remove the nut and seat belt.

  1. Remove the buckle cover.



4. REMOVE FRONT SEAT INNER WITH CENTER BELT ASSEMBLY RH


B125115
  1. Remove the bolt and seat belt.