Home › ENGINE ยท 5L-E › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here


HINT:
  1. Thoroughly clean all parts to be assembled.
  2. Before installing the parts, apply fresh engine oil to all sliding and rotating surfaces.
  3. Replace all gaskets and oil seals with new one.



1. REMOVE VALVE LIFTER
  1. Remove the valve lifter and adjusting shim.

    HINT:
    Arrange the valve lifters and shims in the correct order.



2. REMOVE INTAKE VALVE


    A057444E02
  1. Using SST, compress the valve spring and remove the 2 retainer locks.

    SST
    09202-70020   (09202-00030)

  1. Remove the spring retainer, valve spring, valve and spring seat.

    HINT:
    Arrange the valves, valve springs, spring seats and spring retainers in the correct order.



3. REMOVE EXHAUST VALVE


    A059347E02
  1. Using SST, compress the valve spring and remove the 2 retainer locks.

    SST
    09202-70020   (09202-00030)

  1. Remove the spring retainer, valve spring, valve and spring seat plate washer.

    HINT:
    Arrange the valves, valve springs, spring seat plate washers and spring retainers in the correct order.



4. REMOVE VALVE STEM OIL SEAL


    A057250E01
  1. Using needle-nose pliers, remove the oil seal.



5. REMOVE COMBUSTION CHAMBER SUB-ASSEMBLY


    A057259E02
  1. Using SST, remove the 4 combustion chambers (and shims).

    SST
    09208-48010  

    HINT:
    Arrange the combustion chambers (and shims) in the correct order.



6. REMOVE SEMICIRCULAR PLUG
  1. Remove the semicircular plug from the cylinder head.



7. REMOVE TIGHT PLUG