AIR CONDITIONING UNIT (for Automatic Air Conditioning System) > REASSEMBLY |
| 1. INSTALL EVAPORATOR TEMPERATURE SENSOR |
![]() |
Insert the evaporator temperature sensor as shown in the illustration to install it.
| 2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Install the cooler evaporator to the case.
Attach the temperature sensor clamp.
![]() |
Attach the 2 claws to install the cover.
Install the 4 screws.
| 3. INSTALL COOLER EXPANSION VALVE |
![]() |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.
Install the 2 O-rings to the cooler evaporator.
Using a 4 mm socket hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
| 4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Attach the evaporator case to the blower case.
Install the heater radiator with the screw.
| 5. INSTALL MODE DAMPER SERVO SUB-ASSEMBLY |
![]() |
Set the damper servo so that the cutout part engages with the tooth of the gear to install the damper servo.
Install the 3 screws.
| 6. INSTALL AIR MIX DAMPER SERVO SUB-ASSEMBLY |
![]() |
Set the damper servo so that the cutout part engages with the tooth of the gear to install the damper servo.
Install the 3 screws.
| 7. INSTALL BLOWER ASSEMBLY |
Attach the blower assembly to the air conditioning radiator assembly.
![]() |
Install the blower with the 2 screws.