Home › TRANSMISSION · A340F AUTOMATIC TRANSMISSION › ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM

DTC    P0818    Driveline Disconnect Switch Input Circuit

for Preparation Click here


DESCRIPTION

The TCM detects the signal from the transfer neutral position switch.
This DTC indicates that the transfer neutral position switch remains ON.

DTC No.
DTC Detection Condition
Trouble Area
P0818
Transfer neutral position switch remains ON while vehicle is running under following conditions for 30 sec. (2 trip detection logic):
  1. Vehicle speed is 25 km/h (16 mph) or more
  2. Transfer shift lever is on H
  1. Short in transfer neutral position switch circuit
  2. Transfer neutral position switch
  3. TCM

MONITOR DESCRIPTION

The TCM detects whether or not the transfer shift lever is in neutral by monitoring the signal from the transfer neutral position switch.
If the TCM detects that the transfer shift lever is in neutral under all of the following conditions, the TCM will conclude that there is a malfunction of the transfer neutral position switch:
  1. Transfer neutral position switch indicates that the transfer shift lever is in neutral.
  2. Transfer shift lever is in the H position.
  3. The vehicle is traveling at 25 km/h (16 mph) or more.
  4. The transfer neutral position switch has been ON for more than 30 seconds.
Then the TCM will illuminate the MIL and store the DTC.

WIRING DIAGRAM


C154998E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - BODY GROUND)
C155111E04
  1. Disconnect the T5 switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Transfer Connection
    Specified Condition
    T5-2 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
A110992E09
  1. Remove the transfer indicator switch.

  1. Measure the resistance of the switch when pushing the ball at the tip of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
OK


3.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - TCM)


    C154999E04
  1. Disconnect the T5 switch connector.

  1. Disconnect the T18 TCM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-1 - T18-16 (TFN)
    Below 1 Ω
    T18-16 (TFN) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM