DTC P0818/C2 Driveline Disconnect Switch Input Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0818/C2 | Transfer neutral position switch remains on while the vehicle is being driver under the following conditions for 30 sec. (2 trip detection logic):
|
|

| 1.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - BODY GROUND) |
![]() |
Disconnect the T5 switch connector.
Measure the resistance of the wire harness side connector.
| Transfer Connection | Condition | Specified Condition |
| T5-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.INSPECT NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH) |
![]() |
Remove the transfer indicator switch.
Measure the resistance of the switch when pushing the ball at the tip of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Not pushed | 10 kΩ or higher |
| 1 - 2 | Pushed | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - TCM) |
![]() |
Disconnect the T5 switch connector.
Disconnect the T18 TCM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Condition | Specified Condition |
| T5-1 - T18-16 (TFN) | Always | Below 1 Ω |
| T18-16 (TFN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||