ECD SYSTEM (w/ EGR Cooler) > DTC CHECK / CLEAR |
| CHECK DTC (using intelligent tester) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (Using Intelligent Tester) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC / Clear.
Press the YES button.
| CLEAR DTC (Without using Intelligent Tester) |
![]() |
Perform either one of the following operations.
Disconnect the negative battery cable for more than 1 minute.
Remove the EFI fuse from the engine room junction block, located inside the engine compartment, for more than 1 minute.