DTC P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance |
| DTC Code | DTC Detection Condition | Trouble Area |
| P2772 |
|
|

| 1.CHECK HARNESS AND CONNECTOR (NO. 1 TRANSFER INDICATOR SWITCH - BODY GROUND) |
![]() |
Disconnect the T4 transfer indicator switch connector.
Measure the resistance according to the value(s) in the table below.
| Transfer Connection | Condition | Specified Condition |
| T4-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH) |
![]() |
Remove the transfer indicator switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Not pushed | 10 kΩ or higher |
| 1 - 2 | Pushed | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NO. 1 TRANSFER INDICATOR SWITCH - TCM) |
![]() |
Disconnect the T4 transfer indicator switch connector.
Disconnect the T18 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| T18-15 (L4) - T4-1 | Below 1 Ω |
| T18-15 (L4) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||