AUTOMATIC TRANSMISSION ASSEMBLY (for 1KD-FTV) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE CONSOLE BOX ASSEMBLY |
Remove the console box assembly (Click here).
| 3. REMOVE SHIFT LEVER BOOT ASSEMBLY |
Remove the 4 screws and shift lever boot.
| 4. REMOVE TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY |
![]() |
Remove the 4 bolts and transfer high and low shift lever.
Using needle-nose pliers, remove the snap ring and pull out the shift lever from the shift lever retainer.
| 5. REMOVE NO. 1 ENGINE UNDER COVER |
| 6. REMOVE NO. 2 ENGINE UNDER COVER |
| 7. REMOVE TRANSFER CASE LOWER PROTECTOR |
Remove the 4 bolts and transfer case lower protector.
| 8. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Remove the exhaust pipe (Click here).
| 9. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
Remove the front propeller shaft assembly (Click here).
| 10. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY |
Remove the propeller shaft with center bearing assembly (Click here).
| 11. DRAIN AUTOMATIC TRANSMISSION FLUID |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 12. DISCONNECT OIL COOLER TUBE |
![]() |
Using a union nut wrench, disconnect the tube outlet and tube inlet.
![]() |
Remove the 3 bolts and 3 clamps.
| 13. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the nut and clip and disconnect the control cable.
| 14. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
![]() |
Remove the 2 bolts and control cable bracket from the transmission.
| 15. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Support the transmission with a transmission jack.
| 16. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Remove the 4 set bolts of the No. 1 engine mounting insulator rear.
Remove the 4 nuts, 4 bolts and frame crossmember.
| 17. REMOVE NO. 1 ENGINE MOUNTING INSULATOR REAR |
![]() |
Remove the 4 bolts and engine mounting insulator rear from the automatic transmission.
| 18. DISCONNECT CONNECTOR |
![]() |
Tilt the transmission downward.
Transmission side:
Disconnect the connectors.
Disconnect the park/neutral position switch connector.
Disconnect the transmission wire connector.
Disconnect the 2 speed sensor connectors.
Transfer side:
Disconnect the connectors.
Disconnect the No. 1 indicator switch connector.
Disconnect the No. 2 indicator switch connector.
Disconnect the speed sensor connector.
| 19. DISCONNECT WIRE HARNESS |
| 20. REMOVE STARTER ASSEMBLY |
| 21. REMOVE STIFFENER PLATE |
![]() |
Remove the 4 bolts and stiffener plate RH (with oil cooler tube clamp).
Remove the 4 bolts and stiffener plate LH.
Remove the No. 4 cylinder block insulator.
Remove the No. 2 end plate.
| 22. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Turn the crankshaft to gain access to the 6 torque converter clutch mounting bolts and remove each bolt through the hole of the flywheel while holding the crankshaft pulley bolt with a wrench.
![]() |
Remove the 5 bolts.
Remove the automatic transmission assembly.
| 23. REMOVE TRANSFER ASSEMBLY |
Remove the transfer assembly (Click here).
| 24. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY |