Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    D027961E06
  1. Using SST and a hammer, tap in a new oil seal.

    SST
    09350-30020   (09351-32140)

    HINT:
    The oil seal end should be flush with the outer edge of the pump body.

  1. Coat the lip of the oil seal with MP grease.



2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
  1. Place the oil pump body on the torque converter clutch.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    D027959E01
  1. Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    D027958E01
  1. Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.



5. INSTALL FRONT OIL PUMP BODY O-RING


    D027963E02
  1. Coat a new O-ring with ATF and install it to the oil pump body.



6. INSTALL STATOR SHAFT ASSEMBLY


    D027953E01
  1. Align the stator shaft with the bolt holes.

  1. Install the 14 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }



7. INSTALL CLUTCH DRUM OIL SEAL RING


    D027952E06
  1. Coat 3 new oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together with an overlap distance of 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.

    NOTICE:
    Do not excessively widen the ring.



8. INSPECT OIL PUMP DRIVE GEAR ROTATION


D027962E01
  1. Place the oil pump body on the torque converter clutch.

  1. Check that the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter.



9. INSTALL AUTOMATIC TRANSMISSION CASE O-RING


    D027950E03
  1. Coat a new O-ring with ATF and install it to the oil pump assembly.