Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT BUMPER REINFORCEMENT EXTENSION LH (for 4WD and Pre-Runner)
  1. Attach the claws to install the reinforcement extension.



2. INSTALL FRONT BUMPER REINFORCEMENT EXTENSION RH (for 4WD and Pre-Runner)
  1. Attach the claws to install the reinforcement extension.



3. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


B085202E01
  1. Install the reinforcement with the 4 nuts.

    Torque:
    67 N*m{ 683 kgf*cm , 49 ft.*lbf }



4. INSTALL FRONT BUMPER SIDE RETAINER LH


B085200E01
  1. Attach the 2 claws to install the retainer.

  1. Install the screw.



5. INSTALL FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedures described for the LH side.



6. INSTALL FRONT BUMPER COVER
  1. w/ Fog light:
    Connect the 2 fog light connectors.



    B085206E01
  1. Put protective tape under the front fender.

  1. Attach the 4 claws to install the cover.



    B085205E01
  1. Install the 9 clips.



7. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)


B112763E02
  1. Install the engine side cover with the 3 bolts and 2 clips.



8. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.



9. INSTALL FRONT FENDER LINER LH


B085207E01
  1. Install the fender liner with the 3 clips and screw.



10. INSTALL RADIATOR GRILLE


B108604E01
  1. Push the radiator grille in the direction indicated by the arrow in the illustration. Attach the 5 claws to install the radiator grille.

  1. Install the 2 screws and 2 clips.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


12. PERFORM INITIALIZATION
  1. Perform initialization (Click here)

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.