Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE RADIATOR GRILLE


B085203E01
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Pull the radiator grille in the direction indicated by the arrow in the illustration to detach the 5 claws and remove the radiator grille.



3. REMOVE FRONT FENDER LINER LH


B085207E01
  1. Remove the screw.

  1. Using a clip remover, remove the 3 clips.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed in a later step.



4. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)


B112763E02
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 3 bolts and engine side cover.



5. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.



6. REMOVE FRONT BUMPER COVER


B085205E01
  1. Using a clip remover, remove the 9 clips.



    B085206E01
  1. Put protective tape under the front fender.

  1. Detach the 4 claws and remove the bumper cover.

  1. w/ Fog light:
    Disconnect the 2 fog light connectors.



7. REMOVE FRONT BUMPER SIDE RETAINER LH


B085200E01
  1. Remove the screw.

  1. Using a screwdriver, detach the 2 claws and remove the side retainer.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedures described for the LH side.



9. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


B085202E01
  1. Remove the 4 nuts and reinforcement.



10. REMOVE FRONT BUMPER REINFORCEMENT EXTENSION LH (for 4WD and Pre-Runner)
  1. Using a screwdriver, detach the claws and remove the reinforcement extension.

    HINT:
    Tape the screwdriver tip before use.



11. REMOVE FRONT BUMPER REINFORCEMENT EXTENSION RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.