FRONT BUMPER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE RADIATOR GRILLE |
![]() |
Using a clip remover, remove the 2 clips.
Remove the 2 screws.
Pull the radiator grille in the direction indicated by the arrow in the illustration to detach the 5 claws and remove the radiator grille.
| 3. REMOVE NO. 1 FRONT WHEEL OPENING EXTENSION PAD |
![]() |
Remove the 2 screws and extension pad.
| 4. REMOVE FRONT FENDER LINER LH |
![]() |
Remove the 4 screws.
Using a clip remover, remove the 3 clips.
Partially remove the fender liner.
| 5. REMOVE FRONT FENDER LINER RH |
| 6. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner) |
![]() |
Using a clip remover, remove the 2 clips.
Remove the 3 bolts and engine side cover.
| 7. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner) |
| 8. REMOVE FRONT BUMPER COVER |
![]() |
Using a clip remover, remove the 7 clips.
![]() |
Put protective tape under the front fender.
Detach the 4 claws and remove the bumper cover.
w/ Fog Light:
Disconnect the 2 fog light connectors.
| 9. REMOVE FRONT BUMPER SIDE RETAINER LH |
![]() |
Remove the screw.
Using a screwdriver, detach the 2 claws and remove the side retainer.
| 10. REMOVE FRONT BUMPER SIDE RETAINER RH |
| 11. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY |
![]() |
Remove the 4 nuts and reinforcement.
| 12. REMOVE FRONT BUMPER REINFORCEMENT EXTENSION LH (for 4WD and Pre-Runner) |
Using a screwdriver, detach the claws and remove the reinforcement extension.
| 13. REMOVE FRONT BUMPER REINFORCEMENT EXTENSION RH (for 4WD and Pre-Runner) |