Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > REASSEMBLY

for Preparation Click here


HINT:
When installing the finish plate and name plate, heat the radiator grille, finish plate and name plate using a heat light.

Standard Heating Temperature:
Item
Specified Condition
Radiator grille, finish plate and name plate
20 to 30°C (68 to 86°F)



1. INSTALL NO. 2 FRONT BUMPER EXTENSION INSERT LH
  1. Install the extension insert with the screw.



2. INSTALL NO. 2 FRONT BUMPER EXTENSION INSERT RH
  1. Install the extension insert with the screw.



3. INSTALL FRONT BUMPER HOLE COVER LH
  1. Install the hole cover with the clip.



4. INSTALL FRONT BUMPER HOLE COVER RH
  1. Install the hole cover with the clip.



5. INSTALL FRONT BUMPER EXTENSION LH (w/ Over Fender)


B085198E01
  1. Install the extension with the 6 retainers.



6. INSTALL FRONT BUMPER EXTENSION RH (w/ Over Fender)

HINT:
Use the same procedures described for the LH side.



7. INSTALL FOG LIGHT ASSEMBLY LH WITH BRACKET (w/ Fog Light)


    B085698E01
  1. Install the fog light with the 2 bolts.



8. INSTALL FOG LIGHT ASSEMBLY RH WITH BRACKET


    B087792E01
  1. Install the fog light with the 2 bolts.



9. INSTALL RADIATOR GRILLE EMBLEM


B085201E01
  1. Attach the 3 claws to install the emblem.



10. INSTALL RADIATOR GRILLE FINISH PLATE LH (w/ Plated Moulding)
  1. Clean the grille surface:

    1. Using a heat light, heat the grille surface.

      NOTICE:
      Do not heat the radiator grille excessively.

    2. Remove the double-sided tape from the grille.

    3. Wipe off the stains with cleaner.



  1. If reusing the finish plate:

    1. Using a heat light, heat the finish plate.

      NOTICE:
      Do not heat the finish plate excessively.

    2. Remove the double-sided tape from the finish plate.

    3. Wipe off the stains with cleaner.



    4. B086208E01
    5. Apply new double-sided tape to the finish plate as shown in the illustration.

  1. Install the finish plate.

    1. Remove the peeling paper from the finish plate.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the finish plate to the radiator grille.



11. INSTALL RADIATOR GRILLE FINISH PLATE RH (w/ Plated Moulding)

HINT:
Use the same procedures described for the LH side.



12. INSTALL NO. 1 RADIATOR GRILLE RETAINER
  1. Install the retainer with the 5 screws.