STARTER (for 2.2 kW Type Denso Made) > INSTALLATION |
| 1. INSTALL STARTER ASSEMBLY |
![]() |
A/T:
Connect the ground cable and install the starter with the 2 nuts and bolt.
![]() |
M/T:
Install the starter and ground cable with the nut and bolt.
Install the starter wire to terminal 30 with the nut.
Connect the starter connector.
for A340F A340E:
Install transmission oil filler tube sub-assembly.
Coat a new O-ring with ATF, and install it to the transmission oil filler tube sub-assembly.
Install the oil filler tube with the 2 bolts.
Install the oil dipstick.
| 2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission) |
![]() |
Install the release cylinder with the 2 bolts.
| 3. INSTALL FRONT FENDER SEAL |
Install the seal with the 5 clips.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |