ECM > INSTALLATION |
| 1. INSTALL NO. 2 ECM BRACKET |
![]() |
Install the bracket with the 2 screws.
| 2. INSTALL NO. 1 ECM BRACKET |
![]() |
Install the bracket with the 3 screws.
| 3. INSTALL ECM |
![]() |
Install the ECM with the bolt and 2 nuts.
Connect the 4 connectors.
| 4. INSTALL TRANSMISSION CONTROL ECU ASSEMBLY (for Automatic Transmission) |
![]() |
Install the TCM with the 2 bolts.
Connect the 3 connectors.
| 5. REMOVE TURBO MOTOR DRIVER |
![]() |
Install the turbo motor driver with the bolt.
Connect the connector.
| 6. INSTALL 4WD CONTROL ECU (w/ A.D.D.) |
![]() |
Install the 4WD control ECU with the bolt.
Connect the connector.
| 7. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() |
Attach the 2 hinges to install the door.
![]() |
Push in the sides of the glove compartment door, as indicated by the arrows in the illustration. Then close the door to engage it to the 2 stoppers.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 10. PERFORM REGISTRATION (w/ EGR Cooler) |
Perform registration (Click here).
| 11. PERFORM REGISTRATION (w/o EGR Cooler) |
Perform registration (Click here).
| 12. START ENGINE (w/ EGR Cooler) |
| 13. START ENGINE (w/o EGR Cooler) |