Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 ECM BRACKET


    A191417
  1. for LHD:
    Install the bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



    A224464
  1. for RHD:
    Install the bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



2. INSTALL NO. 1 ECM BRACKET


    A191416
  1. for LHD:
    Install the bracket with the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



    A224463
  1. for RHD:
    Install the bracket with the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



3. INSTALL ECM


    A191421E03
  1. Install the ECM with the bolt and 2 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 4 connectors.



4. INSTALL TURBO MOTOR DRIVER (for Motor Controlled Actuator)


    A191420E03
  1. Install the turbo motor driver with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



5. INSTALL 4WD CONTROL ECU (for 4WD)


    A211934E02
  1. Install the 4WD control ECU with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



6. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


B115417E01
  1. Attach the 2 hinges to install the door.



    B086888E02
  1. Push in the sides of the glove compartment door, as indicated by the arrows in the illustration. Then close the door to engage it to the 2 stoppers.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. PERFORM REGISTRATION (w/ EGR Cooler)
  1. Perform registration (Click here).



9. PERFORM REGISTRATION (w/o EGR Cooler)
  1. Perform registration (Click here).



10. START ENGINE (w/ EGR Cooler)

NOTICE:
After replacing the ECM, the new ECM needs to be initialized (Click here).



11. START ENGINE (w/o EGR Cooler)

NOTICE:
After replacing the ECM, the new ECM needs to be initialized (Click here).