ECM > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() |
Push in the sides of the glove compartment door, as indicated by the arrows in the illustration. Then open the door to release it from the 2 stoppers. Open the door until it is horizontal.
![]() |
Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.
| 3. REMOVE 4WD CONTROL ECU (w/ A.D.D.) |
Disconnect the connector.
![]() |
Remove the bolt and 4WD control ECU.
| 4. REMOVE TCM (for Automatic Transmission) |
Disconnect the 3 connectors.
![]() |
Remove the 2 bolts and TCM.
| 5. REMOVE ECM |
Disconnect the 4 connectors.
![]() |
Remove the bolt, 2 nuts and ECM.