DIESEL THROTTLE BODY (w/ EGR Cooler) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Remove the 3 bolts, 2 nuts and engine cover.
| 3. REMOVE INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR |
![]() |
Detach the 2 clamps.
Disconnect the vacuum hose from the manifold absolute pressure sensor.
Disconnect the IAT sensor connector and manifold absolute diesel pressure sensor connector.
![]() |
Loosen the 2 clamps.
![]() |
Remove the 4 bolts and intercooler.
| 4. REMOVE DIESEL THROTTLE BODY ASSEMBLY |
![]() |
Disconnect the 2 connectors.
![]() |
Remove the 2 bolts, 2 nuts, throttle body and gasket.