Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR (w/o EGR Cooler)

CAMSHAFT POSITION SENSOR (w/o EGR Cooler) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE CAMSHAFT POSITION SENSOR


A112047
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.