GLOW PLUG (w/ EGR System) > INSTALLATION |
| 1. INSTALL GLOW PLUG ASSEMBLY |
![]() |
Using a 12 mm deep socket wrench, install the 4 glow plugs.
| 2. INSTALL NO. 1 GLOW PLUG CONNECTOR |
Install the glow plug connector by uniformly tightening the 4 nuts.
Install the 4 screw grommets.
Install the wire harness with the nut.
| 3. INSTALL EGR VALVE ASSEMBLY |
Install a new gasket and the EGR valve.
| 4. INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY |
| 5. INSTALL INTAKE AIR CONNECTOR |
Install a new gasket and the air connector with the 2 nuts and bolt.
| 6. INSTALL THROTTLE BODY BRACKET |
Install the bracket with the 3 bolts.
| 7. INSTALL DIESEL THROTTLE BODY ASSEMBLY |
![]() |
Install a new gasket and the throttle body with the 2 bolts and 2 nuts.
![]() |
Connect the 2 connectors.
| 8. INSTALL VACUUM SWITCHING VALVE BRACKET |
![]() |
Install the bracket with the 2 bolts.
Connect the vacuum hoses to the 2 locations.
Connect the 2 connectors.
| 9. INSTALL NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY |
![]() |
Connect the pipe (with the 2 air hoses) and install the bolt.
Tighten the 2 clamps.
Connect the vacuum hose to the gas filter.
Connect the manifold absolute pressure sensor connector.
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. PERFORM INITIALIZATION |
Perform initialization (Click here).