Home › ENGINE · 2KD-FTV › EMISSION CONTROL › EGR VALVE (w/o EGR Cooler)

EGR VALVE (w/o EGR Cooler) > INSPECTION

for Preparation Click here



1. INSPECT EGR VALVE


  1. Inspect the EGR valve.



      A099571E01
    1. When a vacuum of 26.7 kPa (200 mmHg, 7.87 in.Hg) is applied to the diaphragm chamber, check that the shaft rises and that air flows out.

    2. Maintaining the above conditions, check that there are no leaks and that the shaft does not lower.

    3. Check that the valve does not have heavy carbon deposits and is not stuck.
      If the result is not as specified, replace the EGR valve.



    A085764E03
  1. Inspect the EGR valve position sensor.

    1. Measure the resistance between terminals 1 (VC) and 2 (E2) of the EGR valve position sensor.

      Standard resistance:
      4.0 to 6.0 kΩ at 20°C (68°F)

      If the result is not as specified, replace the EGR valve.



    A099572E03
  1. Create a vacuum in the diaphragm chamber. Check the resistance between terminals 3 (EGLS) and 2 (E2) of the lift sensor when the valve is fully opened and fully closed.

    Standard resistance:
    EGR Valve Condition
    Specified Condition
    Fully opened
    3.9 kΩ at 20°C (68°F)
    Fully closed
    1.0 kΩ at 20°C (68°F)

    HINT:
    The resistance increases in proportion to the opening angle of the EGR valve.
    If the result is not as specified, replace the EGR valve.