INTAKE MANIFOLD (w/ EGR Cooler) > INSTALLATION |
| 1. INSTALL INTAKE MANIFOLD |
![]() |
Temporarily install a new gasket and the manifold with the 2 nuts and 4 bolts.
Tighten the 2 nuts and 4 bolts in the order shown in the illustration.

![]() |
Install the common rail sub-harness connector to the intake manifold.
| 2. INSTALL INTAKE MANIFOLD INSULATOR |
![]() |
Install the insulator with the 2 bolts.
| 3. INSTALL VACUUM CONTROL VALVE SET |
![]() |
Install the vacuum valve control valve set with the 2 bolts.
Connect the 3 vacuum hoses and 2 connectors.
| 4. INSTALL NO. 3 INTERCOOLER SUPPORT BRACKET |
![]() |
Install the support bracket with the bolt.
| 5. INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY |
![]() |
Temporarily install the leakage pipe with the 3 bolts.
Temporarily install a new gasket with the check valve.
Tighten the 3 bolts and check valve.
Connect the 3 fuel hoses.
| 6. INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY |
![]() |
Temporarily install the No. 4 injection pipe with the union nuts.
Install new injection pipe clamp with the bolt.
![]() |
Using a 17 mm union nut wrench, tighten the injection pipe union nuts on the common rail side.
Using a union nut wrench, tighten the injection pipe union nuts on the injector side.
| 7. INSTALL EGR COOLER |
Install the EGR (Click here).
| 8. INSTALL OIL DIPSTICK GUIDE |
![]() |
Install a new O-ring to the guide.
Apply a small amount of clean engine oil to the O-ring.
Install the guide with the bolt.
Install the injection pipe clamp with the bolt.
| 9. INSTALL MANIFOLD STAY |
![]() |
Install the stay with the 2 bolts.
Connect the 3 vacuum hoses to the 2 VSV.
| 10. BLEED AIR FROM FUEL SYSTEM |
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. CHECK FOR FUEL LEAKS |
Check that there are no leaks from any part of the fuel system when the engine is stopped. If there is fuel leakage, repair or replace parts as necessary.
Start the engine and check that there are no leaks from any part of the fuel system. If there is fuel leakage, repair or replace parts as necessary.
Disconnect the return hose from the common rail.
Start the engine and check for fuel leaks from the return pipe.
If there is fuel leakage, replace the common rail.
Connect the intelligent tester to the DLC3.
Start the engine and push the intelligent tester main switch on.
Select the Fuel Leak test from the Active Test mode on the intelligent tester.
If the intelligent tester is not available, fully depress the accelerator pedal quickly. Increase the engine speed to the maximum and maintain that speed for 2 seconds. Repeat this operation several times.
Check that there are no leaks from any part of the fuel system.
Reconnect the return hose to the common rail.
| 13. PERFORM INITIALIZATION |
Perform initialization (Click here).