INTAKE MANIFOLD (w/ EGR Cooler) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE MANIFOLD STAY |
Disconnect the 3 vacuum hoses from the 2 VSV.
![]() |
Remove the 2 bolts and stay.
| 3. REMOVE OIL DIPSTICK GUIDE |
![]() |
Remove the bolt and injection pipe clamp.
Remove the bolt and guide.
Remove the O-ring from the guide.
| 4. REMOVE EGR COOLER |
Remove the EGR cooler (Click here).
| 5. REMOVE NO. 3 INTERCOOLER SUPPORT BRACKET |
![]() |
Remove the bolt and support bracket.
| 6. REMOVE VACUUM CONTROL VALVE SET |
![]() |
Disconnect the 2 connectors and 3 vacuum hoses.
Remove the 2 bolts and vacuum control valve set.
| 7. REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY |
![]() |
Remove the bolt and disconnect the injection pipe clamp.
![]() |
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.
| 8. REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY |
Disconnect the 3 fuel hoses.
![]() |
Remove the check valve, 3 bolts, leakage pipe and gasket.
| 9. REMOVE INTAKE MANIFOLD INSULATOR |
![]() |
Remove the 2 bolts and insulator from the manifold.
| 10. REMOVE INTAKE MANIFOLD |
![]() |
Disconnect the common rail sub-harness connector from the intake manifold.
![]() |
Remove the 2 nuts, 4 bolts, intake manifold and gasket.