TURBOCHARGER (w/o EGR Cooler) > INSPECTION |
| 1. VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY |
![]() |
Check for deformation and cracks in the turbine wheel on the exhaust side.
If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.
|
*1 | Turbine Wheel |
| 2. INSPECT AXIAL PLAY OF TURBINE SHAFT |
![]() |
Move the turbine shaft in an axial direction and measure the axial play of the turbine shaft using a dial indicator.
| 3. INSPECT RADIAL PLAY OF TURBINE SHAFT |
![]() |
Using a dial indicator, insert the needle of the dial indicator into the oil outlet hole, and set it in the center of the turbine shaft.
Move the turbine shaft in a radial direction and measure the radial play of the turbine shaft.
| 4. CHECK TURBINE SHAFT ROTATION |
![]() |
Rotate the turbine wheel with your finger and check that it rotates smoothly.
| 5. INSPECT ACTUATOR AND WASTE GATE VALVE OPERATION |
![]() |
Disconnect the actuator hose from the compressor housing.
Using SST, apply pressure to the actuator.
| Engine Type | Turbocharger Sub-assembly (Part No.) | Valve Opening Pressure (kPa: Gauge Pressure) | Maximum Pressure (kPa: Gauge Pressure) | Reference: Rod Stroke (mm) |
| 2KD-FTV | 17201-0L030 17201-30120 | 114 | 136 | 0.98 to 1.91 |
| 17201-0L050 | 123 | 147.8 | 0.89 to 1.74 | |
| 17201-30141 | 135 | 156.5 | 0.72 to 1.39 |
Check that the actuator push rod moves and that the waste gate valve opens.
If the rod does not move, replace the turbocharger sub-assembly.
Reconnect the actuator hose to the compressor housing.